There are several operating modes for Auto-Air-fill:

• • Autonomous Automatic mode (remote control independent)

  • Automatic mode Servo port (requires a servo output to which a 3-position switch has been programmed)

  • Automatic mode Telemetry port (only with Jeti and PowerBox core: Telemetry data are transferred)

The compressor can be powered by a 3S Lipo battery.

• In order to save weight, the compressor can also be supplied with power from the "larger" turbine battery in turbine models. It has an Opto coupler to isolate and prevent any interference.

  VSpeak Auto-Air-fill is an onboard compressor for pneumatic chassis mechanics, brakes etc.
  The pressure range can be adjusted as well as some other parameters.
  Once set, the desired pressure range is regulated fully automatically.
  A previously required pressure reservoir can be significantly reduced - or it can be
  dispensed with entirely.
  When air is compressed, heat is generated, with high pressures and long running times of the
  onboard compressor correspondingly a lot of heat. We therefore recommend using a Teflon
  hose (outer diameter 4mm) as the direct compressed air connection.
  The pressure sensor of the onboard compressor is calibrated upon delivery - but can also be
  recalibrated at any time.